When using the corns machine, observe the surrounding environment in advance, preferably not in places that are too humid and unstable.
The eyelet machine is also called the eyelet machine or the eye machine;
The principle of the operation of the corn-eye machine is similar to that of the riveting machine. It is driven by a motor (cylinder), and the high-speed punching force is instantaneously applied to t
The corns machine is mainly used for the riveting of the eyelet with the bottom buckle, and the upper and lower buckles are automatically fed,
The position of the weldment must be very precise and must be within the focus of the laser bea
The amount of heat input can be minimized, the metallographic range of the heat affected zone is small, and the deformation due to heat conduction is also the lowest.
It belongs to the fusion welding, with the laser beam as the energy source, impacting on the weldment joint.
The laser welding machine uses a high-energy laser pulse to locally heat the material in a small area. The energy of the laser radiation spreads to the inside of the material through heat conduction,
15KHZ high-voltage, high-frequency electric signal is generated by ultrasonic generator, converted into mechanical oscillation of the same frequency through the piezoelectric inverse effect of the tra
The solar cell automatic welding machine (see the figure below) can automatically and continuously weld the front and back of the battery sheet according to the setting requirements to form a battery
